10 Apps That Can Help You Control Your Peugeot 308 Key Fob
Peugeot 308 Key Fob Replacement
Peugeot's 308 may be slightly old however it's still eye-catching. It's not the most luxurious car in its class It's an Ford Focus or Volkswagen Golf will shield you from road imperfections, but it's a relaxing and a civilized drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips can assist whether the issue is persistent or intermittent.
Water Damage
If you happen to leave your fob in a puddle or get it wet while swimming, kayaking, canoeing, rafting or canyoning, it's more likely to suffer water damage. The best way to stop this from happening is to always keep it in a dry, dry bag when you're going outdoors or doing activities in which the fob may be exposed to excessive amounts of water.
It's also important to make sure that the fob is completely dried out prior to opening it up and then use it again. If you notice any smells emanating from the fob (such as industrial liquid or windshield washer fluid) It's another indicator that it is submerged.
A wet circuit board can cause the battery to discharge its charge or even explode. If you're able fish your key fob 308 out of the water body it was stuck in, flip the button side down and shake out as much water as you can before opening the case. After you open it, take out the battery and clean the circuit board with a cotton swab dipped in 90-percent isopropyl alcohol.
Other causes why your Peugeot 308 remote entry keyless system might not function could be due to a dead coin-cell battery or receiver module issue signal interference or a damaged chip. If none of the above are the cause, you can try resetting the system by removing the battery at 12 volts for about 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with remote start technology that allows drivers to start their car from a distance, allowing them to warm up or cool down the vehicle before they get in. This feature is very beneficial particularly during the cold winter months. The remote start system may stop working for a variety reasons, such as the dead battery in the coin-battery.
A coin-shaped battery located inside the key fob will last a time of between two and four years, depending on how often it's utilized and where it was purchased. The date of use is typically written on the package or in the manual.
If the key fob stops working after exposure to water that is clean, you should remove the battery, then clean the chip using a paper towel and isopropyl alcohol, and then dry it completely before replacing it. If Read Home expose it to salty or soapy water, the chip might be damaged and you'll require replacing the key fob in total.
If you're not certain the battery is in good condition You can test its voltage using a multimeter set to the car's voltage range. Connect it to the terminals for minus and plus. If the voltage is less than 12-13 volts it is time to replace the battery. You can also reset your computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should be able to start after this.
Faulty Receiver Module
If you aren't seeing the "Key Detected" message, it could mean the receiver module not working properly. It's the part which sends out an alert when the key fob turns on. It also acts as an alarm, and stops the vehicle from starting without the correct key.
The cause could be a number of causes, such as water damage or simply aging. If your Peugeot 308 key fob has been exposed dirty tap water, as in, the electronic chip inside may be damaged. In this scenario, you'll need to remove it and thoroughly clean it with isopropyl or electronic cleaner. Once it's dry you can put the battery back in and test it again.
If the issue persists you're probably in need of a idea to visit an area Peugeot specialist or locksmith. They'll be able use a diagnostic tool to identify the issue and fix it.
Losing your Peugeot keys to your car is an extremely stressful experience. However, a qualified auto locksmith can fix the problem in minutes. They can cut a brand new key and programme it to your vehicle, so you're off the road in the shortest amount of time. Click here to locate the nearest locksmith.
Faulty Electronic Chip
The electronic chip that is in the Peugeot 308 key fob is a critical role in the remote control system. If the chip is damaged, you could experience difficulties starting your vehicle or receive a message saying "anti-theft". In this case, the only solution is to replace the key. Luckily, professional auto locksmiths can complete the task in the shortest amount of time.
The chip in your Peugeot 308 key fob can be damaged due to sweat, water damage dirt, or other reasons. If your Peugeot key fob has been exposed to soapy or dirty water, it needs to be cleaned right away. You can use a paper towel and isopropyl alcohol for cleaning the electronic component. The battery should then be allowed to fully dry.
Radio interference can cause a key fob to stop functioning. This could be due to other devices operate on the same frequency as your Peugeot keyfob. This can be caused by unsafe conditions or objects that are in the vicinity of the vehicle. If you experience this issue, it is best to visit the Peugeot dealership.
The Peugeot 207/308 Key Fob is fragile and requires special care. You should not drop it or throw it around. If you lose something, try to locate it as soon as you are able to. You can reset all the on-board computers by disconnecting the 12 volt battery for a few minutes. Disconnect the negative cable prior to the positive.